How to Determine the Sieve Diameter of Metal Crusher?

Metal crusher is a new kind of energy-saving and environmental protection equipment which is specially used for recycling scrap metal resources in order to improve the utilization of metal materials. Scrap metal crusher has not only increased its production capacity and crushing efficiency, but also expanded the scope of applications.

The distance between the hammer and screen of metal crusher refers to the distance between hammer ends to the sieve, which is beneficial to solve the blockage problem of coarse crushing and fine crushing of materials. If the gap is too large, the material layer will be thicker; the hammer cannot effectively discharge materials. If the gap is too small, the material will not across the screen. In order to overcome the above problem, the gap should be be repeatedly check to change the pin shaft position or the hammer length.

When screen materials, the powder materials must be smaller than the aperture diameter. If the material is larger than the diameter of the hole, the crushing process will cause many layers. Material layer is divided into many different levels of speed, when the level reaches a considerable amount of time; the hammer force is difficult to transfer to the layer sieve sheet. When the motion speed is less than a certain value, the screen will plug materials. The design of mesh size should be based on the metal particle size of different requirements of customers. In the actual production, it can be followed in the actual production experiences in the past to solve practical problems.

Fote Machinery is a manufacturer of metal crusher in China. We have developed the metal can crusher recycling machine, which has caught up with the same industry after years of research. Metal crusher can tear all kinds of metal and circuit board materials into manageable size, which is the ideal equipment for metal recovery, metal smelting, iron and steel enterprises. Welcome to contact us!